Indesit CE60N1 (X) EX S Instrucciones de uso descargar pdf (Pagina 3)

! Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified

professional according to the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the appliance has been

disconnected from the electricity supply.

Positioning and levelling

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, dining room or the bed-sit

(not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 200 mm

away from them.

• If the cooker is

installed underneath a wall

cabinet, there must be a

minimum distance of 420

mm between this cabinet

and the top of the hob.

This distance should be

increased to 700 mm if

the wall cabinets are

flammable (

see figure

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet* into the places provided

on each corner of the base of

the cooker (

see figure

The legs* provided with the

appliance fit into the slots on

the underside of the base of the

cooker.

Electrical connection

Fitting the power supply cable

Opening the terminal board:

• Using a screwdriver, prise on the side tabs of the

terminal board cover;

• Pull open the cover

of the terminal board.

To install the cable, proceed as follows:

• unscrew the wire clamp screw and the contact

screws

! The jumpers are factory-set for a single-phase

230V connection (

see figure

• to make the electrical connections illustrated in

figure, use the two jumpers housed in the box

(

see figure

- reference “

P”)

• fasten the supply cable in place with the clamp

and close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate located on the

appliance.

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains. The circuit-breaker

must be suitable for the charge indicated and must

comply with current electrical regulations (the

earthing wire must not be interrupted by the circuit-

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.

Installation

Only available in certain models.

1 2 3 4 5 6 7 8 ... 51 52

Comentarios a estos manuales

Sin comentarios

Indesit CE60N1 (X) EX S Instrucciones de uso Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Indesit CE60N1 (X) EX S