Indesit IP 751 S (IX) AUS Instrucciones de uso Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
AUS
9
The position of the corresponding gas burner or electric
hotplate* is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
Off
Maximum
Minimum
To ignite a burner proceed as follows:
Press and turn the control knob counterclockwise
until the knob points to High. Keep pressing the
knob inwards until the probe heats up. Release the
knob.
Check that the gas has been lit. If the burner fails to
ignite try again. If the burner fails to ignite after 3
attempts, wait a few minutes for the gas to disperse
before making any further attempts.
If the burner still fails to ignite, a match or lighting
device can be used, but care must be taken. If the
problem persists, contact place of purchase or their
appointed agent for service.
If the flame has excessive yellowing, or appears to
lift off the burner ports, or makes a loud noise, turn
the burner off and call your service agent.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the  position).
Lighting the burners for the first time
If the appliance is being used for the first time, or if
it has not been used for a long period of time, it may
be necessary to purge the gas lines of excess air
before you can successfully light the burners.
To do this, turn each burner to High for 10-15
seconds and press the ignition button several times.
If the burner does not light, repeat this procedure
twice more. Wait 1-2 minutes for any gas build up to
disperse before allowing any further gas flow.
Start-up and use
Practical advice on using the burners
To ensure the burners operate efficiently:
Use appropriate cookware for each burner (see table)
so that the flames do not extend beyond the bottom of
the cookware.
Always use cookware with a flat base and a cover.
When the contents of the pan reach boiling point, turn
the knob to minimum.
Do not use pans which are unstable or which have
a warped or damaged base.
Ensure the pot sits securely on the trivet and is
centred above the burner.
Burner ø Cookware diameter (cm)
Semi-Rapid (S) 16 – 20
Auxilliary (A) 10 – 14
Mini WOK (MW) 22 – 24
Pans to be used on 60 cm hobs
Burner ø Cookware diameter (cm)
Reduced Rapid (RR) 24 – 26
Semi-Rapid (S) 16 – 20
Auxilliary (A) 10 – 14
Mini WOK (MW) 24 – 26
Pans to be used on 75 cm hobs
To identify the type of burner, refer to the designs in the
section entitled, "Technical Specifications".
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios