Indesit PCN 642 T/IX/A SA Instrucciones de uso descargar pdf (Pagina 8)

Start-up and use

! The position of the corresponding gas burner is shown on every knob.

Gas burners

Each burner can be adjusted to one of the following settings using the

corresponding control knob:

● Off

Maximum

Minimum

To light one of the burners, hold a lit match or lighter near the burner and, at

the same time, press down and turn the corresponding knob anti-clockwise

to the maximum setting.

Since the burner is tted with a safety device, the knob should be pressed

for approximately 2-3 seconds to allow the automatic device keeping the

ame alight to heat up.

When using models with an ignition button, light the desired burner pressing

down the corresponding knob as far as possible and turning it anticlockwise

towards the maximum setting.

! If a ame is accidentally extinguished, turn off the control knob and wait for

at least 1 minute before trying to relight it.

To switch off the burner, turn the knob in a clockwise direction until it stops

(when reaches the “●” position).

The “separate double ame” burner*

This burner consists of two concentric burners which can operate either

together or separately.

Use of the double ame on the maximum setting gives a very high power

which reduces cooking times with respect to conventional burners.

Moreover the double ame crown provides a more uniform distribution of heat

on the bottom of the pan, when using both burners on minimum.

To ensure that the double-ame burner is used to its full potential,

never set the inside ring to minimum and the outside ring to maximum

at the same time.

Pots and pans of all sizes can be used. In the case of the smaller pots and pans

we recommend the use of only the internal burner.

There is a separate control knob for each of the “separate double ame”

burners.

The knob marked by the symbol operates the external burner;

The knob marked by the symbol operates the internal burner.

To turn on one of the rings, press the relative knob in all the way and turn it

anti-clockwise to the high setting .

The burner is tted with an electronic igniter that automatically starts when

the knob is pressed in.

Since the burner is equipped with a safety device, after lighting the burner

keep the knob pressed in for about 2-3 seconds to allow the device which

keeps the ame lit automatically to heat up.

The selected burner can be regulated using the corresponding knob, as

follows:

● Off

Maximum

Minimum

To switch off the burner, turn the knob in a clockwise direction until it stops

(when reaches the “●” position).

Practical advice on using the burners

To ensure the burners operate efciently:

• Use appropriate cookware for each burner (see table) so that the ames

do not extend beyond the bottom of the cookware.

• Always use cookware with a at base and a cover.

• When the contents of the pan reach boiling point, turn the knob to minimum.

Reduced Rapid (RR)

Semi Rapid (S)

Auxiliary (A)

Triple Crown (TC)

Ø Cookware diameter (cm)

24 - 26

16 - 20

10 - 14

24 - 26

Burner

Pans to be used on 60 cm hobs

Semi Rapid (S)

Triple Crown (TC)

Double Flame (DCDR internal)

Double Flame (DCDR external)

16 - 20

24 - 26

10 - 14

26 - 28

Burner

Pans to be used on 75 cm hobs

Ø Cookware diameter (cm)

! On the models supplied with a reducer shelf, remember that this should be

used only for the Double ame internal (DCDR internal) burner when you use

casserole dishes with a diameter under 12 cm.

To identify the type of burner, refer to the designs in the section entitled, “Burner

and Nozzle Specications”.

• For maximum stability, always make sure that the pan supports are

correctly tted and that each pan is placed centrally over the burner.

• Pan handles should be positioned in line with one of the support bars on

the pan support grid.

• Pan handle should be positioned so not to protrude beyond the front edge

of the hob.

The more variable aspect in terms of pan

stability can often be the pan itself, (or

the positioning of that pan during use).

Well balanced pans, with at bases that

are placed centrally over the burner,

with the pan handles aligned with one

of the support ngers obviously offer the

greatest stability.

Precautions and tips

! This appliance has been designed and manufactured in compliance with

international safety standards. The following warnings are provided for safety

reasons and must be read carefully.

General safety

• This is a class 3 built-in appliance.

• Gas appliances require regular air exchange to maintain efcient

operation. When installing the hob, follow the instructions provided

in the paragraph on “Positioning” the appliance.

• These instructions are only valid for the countries whose symbols

appear in the manual and on the serial number plate.

• The appliance was designed for domestic use inside the home and is not

intended for commercial or industrial use.

* Only available on certain models.

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Indesit PCN 642 T/IX/A SA Instrucciones de uso Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Indesit PCN 642 T/IX/A SA