Indesit PK 640.1 R X /HA Instrucciones de uso Pagina 19
- Pagina / 64
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
GB
19
There is an adjustable L-shaped pipe fitting on the
appliance supply ramp and this is fitted with a seal in
order to prevent leaks. The seal must always be replaced
after rotating the pipe fitting (seal provided with
appliance). The gas supply pipe fitting is a threaded 1/2
gas cylindrical male attachment.
Connecting a flexible jointless stainless steel pipe to a
threaded attachment
The gas supply pipe fitting is a threaded 1/2 gas
cylindrical male attachment.
These pipes must be installed so that they are never
longer than 2000 mm when fully extended. Once
connection has been carried out, make sure that the
flexible metal pipe does not touch any moving parts and
is not compressed.
! Only use pipes and seals that comply with current
national regulations.
Checking the tightness of the connection
! When the installation process is complete, check the
pipe fittings for leaks using a soapy solution. Never use a
flame.
Adapting to different types of gas
To adapt the hob to a different type of gas other than
default type (indicated on the rating plate at the base of
the hob or on the packaging), the burner nozzles should
be replaced as follows:
1. Remove the hob grids and slide the burners off their
seats.
2. Unscrew the nozzles using a 7 mm socket spanner,
and replace them with nozzles for the new type of gas
(see table 1 “Burner and nozzle characteristics”).
3. Reassemble the parts following the above procedure in
the reverse order.
4. Once this procedure is finished, replace the old rating
sticker with one indicating the new type of gas used.
Sticker are available from any of our Service Centres.
Replacing the nozzles on separate “double flame “
burners:
1. remove the grids and slide the burners from their
housings. The burner consists of 2 separate parts (see
figure);
2. unscrew the burers with a 7 mm wrench spanner. The
internal burner has a nozzle, the external burner has
two (of the same size). Replace the nozzle with models
suited to the new type of gas (see table 1).
3. replace all the components by repeating the steps in
reverse order.
Replacing the Triple ring burner nozzles
1. Remove the pan supports and lift the burners out of
their housing. The burner consists of two separate parts
(see pictures).
2. Unscrew the nozzles using a 7 mm socket spanner.
Replace the nozzles with models that are configured
for use with the new type of gas (see Table 1). The two
nozzles have the same hole diameter.
3. Replace all the components by completing the above
operations in reverse order.
• Adjusting the burners’ primary air :
Does not require adjusting.
• Setting the burners to minimum:
1. Turn the tap to the low flame position.
2. Remove the knob and adjust the adjustment screw,
which is positioned in or next to the tap pin, until the
flame is small but steady.
! In the event of single-control DRDA (DCDR) burners,
adjustment can be performed by intervening on the 2
screws located near the tap pin (see picture).
3. Having adjusted the flame to the required low setting,
while the burner is alight, quickly change the position of
the knob from minimum to maximum and vice versa
several times, checking that the flame does not go out.
4. Some appliances have a safety device (thermocouple)
fitted. If the device fails to work when the burners are
set to the low flame setting, increase this low flame
setting using the adjusting screw.
Inner DRDA (DCDR)
burner adjustment
Total DRDA
(DCDR) burner
adjustment
- Istruzioni per l’uso 1
- Installazione 2
- Collegamento elettrico 3
- Collegamento gas 3
- Regolazione 4
- DCDR interno 4
- DCDR totale 4
- Descrizione 8
- Avvio e utilizzo 9
- Precauzioni e consigli 13
- Manutenzione e cura 14
- Anomalie e rimedi 15
- Operating Instructions 16
- Installation 17
- Electrical connection 18
- Gas connection 18
- Total DRDA 19
- (DCDR) burner 19
- Inner DRDA (DCDR) 19
- KO !KO ! 22
- Description of the 23
- Start-up and use 24
- Pans to be used on 75 cm hobs 25
- Precautions and tips 27
- Maintenance and care 28
- Troubleshooting 29
- Mode d’emploi 30
- Raccordement électrique 32
- Raccordement gaz 33
- DCDR total 34
- Pour la Luxembourg 36
- Description 40
- Mise en marche et 41
- Précautions et conseils 44
- Nettoyage et entretien 45
- Anomalies et remèdes 46
- Manual de 47
- Instalación 48
- Conexión eléctrica 49
- Conexión de gas 49
- Regulación 51
- 30 0,30 0,90 52
- 65 64 0,90 52
- Descripción 55
- Puesta en 56
- Corona Triple (TC) 57
- Precauciones y consejos 59
- Mantenimiento y cuidados 60
- Anomalías y soluciones 61
- 12/2011 - 195092162.01 64
- XEROX FABRIANO 64
Relacionado con productos y manuales para Placas Indesit PK 640.1 R X /HA
Placas Indesit PI 640 AS (AN) R Instrucciones de uso
(56 paginas)
(56 paginas)
Placas Indesit PIM 604 (IX) GB Instrucciones de uso
(12 paginas)
(12 paginas)
Placas Indesit K1E107(W)/RU Instrucciones de uso
(24 paginas)
(24 paginas)
Placas Indesit SCH IF 621 CPT B Instrucciones de uso
(72 paginas)
(72 paginas)
Placas Indesit K3G2(W)/G Instrucciones de uso
(16 paginas)
(16 paginas)
Placas Indesit HI 20.B (IX) Z Instrucciones de uso
(36 paginas)
(36 paginas)
Placas Indesit KN1E17(W)/RU S Instrucciones de uso
(24 paginas)
(24 paginas)
Placas Indesit PK 640 R L GH AG Instrucciones de uso
(28 paginas)
(28 paginas)
Placas Indesit I5GG1G(X) U Instrucciones de uso
(56 paginas)
(56 paginas)
(3 paginas)
Placas Indesit KN6G21S(W)/I S Instrucciones de uso
(48 paginas)
(48 paginas)
Placas Indesit PKLL 641 D2/IX/A Instrucciones de uso
(28 paginas)
(28 paginas)
Placas Indesit SCHI 633 T L Instrucciones de uso
(72 paginas)
(72 paginas)
Placas Indesit TIP 844 DO L Instrucciones de uso
(84 paginas)
(84 paginas)
Placas Indesit KIO 633 T Z Instrucciones de uso
(80 paginas)
(80 paginas)
Placas Indesit EHP 750 T (X)/HA Instrucciones de uso
(20 paginas)
(20 paginas)
Samsung WF1762W5C/YLO manuals
Owner’s manuals and user’s guides for Washing machines Samsung WF1762W5C/YLO.
We providing 1 pdf manuals Samsung WF1762W5C/YLO for download free by document types: User Manual
Comentarios a estos manuales