Indesit VIS 640 C Instrucciones de uso descargar pdf (Pagina 5)

CONTROL PANEL

FIRST TIME USE

POWER MANAGEMENT

Thanks to the “Power management” function, the user can set the

maximum power the hob can reach, as required.

This setting is possible at any time and is maintained until the next

change.

By setting the required maximum power, the hob automatically adjusts

distribution in the various cooking zones, ensuring that this limit is

never exceeded; with the advantage of also being able to manage all

the zones simultaneously, but without overload problems.

4 maximum power levels are available and showed on display: 2.5kW –

4.0kW – 6.0kW – 7.2kW. (7.2 kW is considered as max power of cooktop).

At the time of purchase, the hob is set to maximum power.

To set the hob power:

After plugging the appliance into the electrical socket, in the rst 60

seconds it is possible to set the required power level by running the

following points:

• Press for approximately 3 seconds both (step 1).

• Press the Power Management button to conrm the previous

step (step 2). The display shows .

• Press to set the chosen level amongst the dierent options

available (step 3). The light comes on together with the in-use lights

for the individual cooking zones.

• Press the Power Management button to conrm the previous

step (step 4). The display shows the set level which ashes for

approximately 2 seconds; after which the hob emits an acoustic

signal and then turns itself o; it is now ready for use.

In case of an error when setting the power, the symbol appears in

the middle and an acoustic signal sounds for about 5 seconds. In this

case repeat the conguration procedure from the beginning. If the error

occurs again, contact the After-Sales Service.

During normal use, if the user tries to increase the maximum available

power level when reached, the level of the zone in use ashes twice and

an acoustic signal sounds.

To obtain a higher power in that zone, it is necessary to manually

decrease the power level of one or more already active cooking zones.

ACCESSORIES

POTS AND PANS

Only use pots and pans made from ferromagnetic

material which are suitable for use with induction hobs.

To determine whether a pot is suitable, check for the

symbol (usually stamped on the bottom). A magnet

may be used to check whether pots are magnetic.

RECOMMENDED POT BOTTOM WIDTHS

Place the pot on the required cooking zone before switching the hob on.

For good cooking results, the diameter of the base of the pot should

match the size of the hotplate.

IMPORTANT: The cooking zones will not switch on if pots are not the

right size.

To determine the size of the pot please measure the base of the pot

and refer to recommended pots bottom width table, for perfect usage

and correct pan detection. Each cooking zone has a minimum limit

of detecting pans, which varies depending on the material of the pan

being used. You should therefore use the cooking zone that is most

suitable for the diameter of your pan.

DIAMETER cm MAX cm MINcm

14,5 14,5 10

18 18 12

21 21 15

NOOK

RECOMMENDED POT POSITION

For best performance, when you use two pots simultaneously, put them

according to the pictures below:

IMPORTANT: To avoid a permanent damage the hob:

• do not use pots with bottoms that are not at;

• do not use metal pots with enamelled bottom;

• do not place hot pots/pans over the control panel.

Control panel lock

Power Management

Timer/ Lock function

button Power

On/O

Cooking zone controls and corresponding display

Slider

Quick access

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Indesit VIS 640 C Instrucciones de uso Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Indesit VIS 640 C