Indesit KP9F11SX-G Manual de usuario descargar pdf (Pagina 4)

 Having obtained the low flame setting required

and with the burner lit, abruptly change the

position of the knob several times from minimum

to maximum and vice versa and check that the

flame does not go out.

 In appliances fitted with the safety device

(thermocouple), should the device fail to work with the

burners set to the low flame setting, increase the low

flame setting of the same on the adjusting screw.

Once the adjustment has been made, remount the

seals on the by-passes using sealing wax or similar.

Electrical connection

THE APPLIANCE MUST BE EARTHED

The appliance is designed to work with alternating

current at the supply voltage and frequency indicated

on the rating plate (situated on the rear part of the

appliance and on the last page of the instruction

booklet) or at the end of the instruction booklet. Make

sure that the local supply voltage corresponds to the

voltage indicated on the rating plate.

To connect directly to the mains supply, a double-

pole switch with a contact separation of at least 3

mm suitable for the load and complying with current

standards and regulations, must be fitted between the

appliance and the mains supply outlet. The yellow-

green earth wire must not be interrupted by the switch.

The supply cable must be in such a position that no

part of it can reach a temperature of 50 °C above

room temperature. Do not use adapters or shunts as

they could cause heating or burning. Before

connecting to the power supply, make sure that:

 the limiter valve and the domestic system can

withstand the load from the appliance (see rating

plate);

 the supply system is efficiently earthed according to

standards and laws in force;

 the socket or double-pole switch are easily

accessible when the appliance is installed.

FAILURE TO OBSERVE THE ACCIDENT-PREVENTION

REGULATIONS RELIEVES THE MANUFACTURER OF

ALL LIABILITY.

Important: the wires in the mains lead are coloured

in accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the wires in the mains lead may

not correspond with the coloured markings

identifying the terminals in your plug, proceed as

follows:

Connect the Green & Yellow wire to terminal marked

E or

or coloured Green or Green & Yellow.

Connect the Brown wire to the terminal marked L or

coloured Red.

Connect the Blue wire to the terminal marked N or

coloured Black.

Replacing the cable

Use a rubber cable of the type H05VV-F with a

suitable cross section 3 x 1.5 mm².

The yellow-green earth wire must be 2-3 cm longer

than the other wires.

Disposal

 When disposing of packaging material: observe

local legislation so that the packaging may be

reused.

 The European Directive 2002/96/EC relating to

Waste Electrical and Electronic Equipment (WEEE)

states that household appliances should not be

disposed of using the normal solid urban waste

cycle. Exhausted appliances should be collected

separately in order to optimise the cost of re-using

and recycling the materials inside the machine,

while preventing potential damage to the

atmosphere and to public health. The crossed-out

dustbin is marked on all products to remind the

owner of their obligations regarding separated

waste collection.

For further information relating to the correct

disposal of exhausted household appliances,

owners may contact the public service provided or

their local dealer.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Indesit KP9F11SX-G Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Cocina Indesit KP9F11SX-G