Indesit K 343 M(X)/EU Instrucciones de uso descargar pdf (Pagina 6)

• remove the knob and adjust the regulation screw, which

is positioned in or next to the tap pin, until the flame is

small but steady.

N.B.: in the case of liquid gas, the regulation screw

must be screwed in to the bottom.

• check that the flame does not turn off when you turn

the tap quickly from high to low.

d Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Important

On completion of the operation, replace the old rating

sticker with one indicating the new type of gas used. This

sticker is available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary)

from the recommended pressure, it is necessary to fit a

suitable pressure regulator onto the inlet pipe in

compliance with current National Regulations relative to

“regulators for channelled gas”.

Burner and Nozzle Specifications

Table1 (For Hungary)

G 20 G 25.1 G 30

Burner By-pass

1/100 (mm)

Thermal

power kW

Nozzle

1/100 (mm)

Thermal

power kW

Nozzle

1/100 (mm)

Thermal

power kW

Nozzle

1/100 (mm)

Fast (R) 41 3,30 116 2,60 116 2,60 86

Semi Fast (S) 30 2,10 106 1,70 106 1,70 70

Auxiliary (A) 30 1,15 79 0,90 79 0,90 50

Supply pressures 25 mbar 25 mbar 30 mbar

At 15°C and 1013 mbar-dry gas

P.C.I. G20 37,780 MJ/m

P.C.I. G30 122,8 MJ/m

P.C.I. G25.1 32,510 MJ/m

K 342 M/EU

K 342 MS/EU

K 343 M/EU

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Comentarios a estos manuales

Sin comentarios

Indesit K 343 M(X)/EU Instrucciones de uso Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Indesit K 343 M(X)/EU