Indesit B 40 L/CS SF Instrucciones de uso descargar pdf (Pagina 14)

Instructions for use

The symbols near the knobs show the position of the relative

burner on the hob. The burners are fitted with automatic

ignition and thermocouple safety device, which automatically

cuts off the gas from the burner in a few seconds if the flame

accidentally goes out during operation.

To ignite a burner, proceed as follows:

• turn the relative knob counter-clockwise until the pointer is

on the high-flame symbol;

• press the knob down fully to activate the automatic gas

ignition ;

• keep the knob pressed down for about 10 seconds with the

flame lit to allow the safety thermocouple to be heated;

• release the knob, checking that the flame is stable. If it is

not, repeat the operation.

For minimum power, turn the knob towards the low flame

symbol. Intermediate positions are possible by putting the

knob anywhere between the high and the low flame symbol.

To turn off the burner, turn the knob clockwise to the off

position " " .

Adjusting the flame level

The flame level is adjusted by pressing the control knob and

turning it anticlockwise to the following positions:

Black circle = off

full flame

small flame

Important:

• Do not activate the automatic ignition device for more than

15 consecutive seconds.

• Difficulty in ignition is sometimes due to air inside the gas

duct.

• If a burner flame accidentally goes out, the gas continues

to exit for a few moments before the safety device activates.

Turn the control knob to the off position and do not attempt

ignition again for at least 1 minute, thereby letting the gas

disperse, which could otherwise be a danger.

• When the appliance is not in operation, check that the knobs

are in the off position " ". The main gas supply cut-off

cock should also be closed.

Note When there is no electricity supply, the burners can be

lit with a match after turning the control knob to the flame

position.

To turn on one of the burners, place a lighted match or lighter

near the burner, press the knob all the way in and turn it anti-

clockwise to the "High" setting.

Since the burner is equipped with a safety device "F", after

lighting the burner keep the knob pressed in for about 6 seconds

to allow the device which keeps the flame lit automatically to

heat up.

To turn off a burner, turn the knob clockwise until it stops (it

should be on the “ ” setting).

To obtain the best results with the cooktop, several

fundamental rules should be followed while cooking or

preparing food. Use cookware with a flat bottom to make

certain that the pot sets properly on the cooking area.

Burner ø Cookware diameter (cm)

A. Auxiliary 6 – 14

B. Semi-Rapid 15 – 22

C. Rapid 21 – 26

Using the burners

To obtain maximum efficiency from the burners, it is advisable

to only use pans with a diameter suitable for the burner being

used, so that the flame does not extend beyond the pan base

(see following table).

When a liquid starts boiling, it is advisable to turn the flame

down just enough to keep the liquid simmering.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentarios a estos manuales

Sin comentarios

Indesit B 40 L/CS SF Instrucciones de uso Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para No Indesit B 40 L/CS SF