Indesit TEP 747 D L Instrucciones de uso descargar pdf (Pagina 29)

with the induction principle (ferromagnetic material). We

especially recommend pans made from: cast iron, coated

steel or special stainless steel adapted for induction.

Use a magnet to test the compatibility of the cookware.

SUITABLE

UNSUITABLE

Cast iron

Enamelled steel

Special stainless steel

Copper,

Aluminium, Glass, Earthenware,

Ceramic, non magnetic Stainless steel

In addition, to obtain the best results from your hob:

• Use pans with a thick, flat base in order to fully utilise

the cooking zone.

• Always use pans with a diameter which is large enough

to cover the hotplate fully, in order to use all the

available heat.

• Make sure that the base of the cookware is always

clean and dry, in order to fully utilise and extend the life

of both the cooking zones and the cookware.

• Avoid using the same cookware which has been used

on gas burners: the heat concentration on gas burners

may distort the base of the pan, causing it not to

adhere correctly.

Safety devices

Pan sensor

Each cooking zone is equipped with a pan sensor

device. The hotplate only emits heat when a pan with

suitable measurements for the cooking zone is placed

on it. If the power level indicator display flashes, this

may be because:

• An incompatible pan

• A pan whose diameter is too small

• The pan has been removed from the hotplate.

Residual heat indicators

Each cooking zone is equipped with a residual heat

indicator. This indicator signals which cooking zones

are still at a high temperature. If the power display

shows

, the cooking zone is still hot. It is

possible, for example, to keep a dish warm or melt

butter or chocolate. As the cooking zone cools, the

power display will show

. The display switches off

when the cooking zone has cooled sufficiently.

Overheating protection

If the electronic elements overheat, the hob switches off

automatically and

F appears on the display, followed by a

flashing number. When the temperature has reached a

suitable level, this message disappears and the hob may

be used again.

Safety switch

The appliance has a safety switch which automatically

switches the cooking zones off after they have been in

operation for a certain amount of time at a particular

power level. When the safety switch has been triggered,

the display shows “

0”.

For example: the rear right-hand hotplate is set to 5 and

will switch off after 7 and a half hours of continuous

operation, while the front left-hand hotplate is set to 2 and

will switch off after 9 and a half hours.

Power level Maximum operating time in hour

1 10

2 9,5

3 9

4 8,5

5 7,5

6 7

7 6,5

8 6

9 5,5

10 5

11 4

12 3,5

13 3

14 2,5

15 2

16 1

Buzzer

This can also indicate several irregularities:

• An object (a pan, cutlery, etc.) has been placed on the

control panel for more than 10 seconds.

• Something has been spilt on the control panel.

• A button has been pressed for too long. All of the

above situations may cause the buzzer to sound.

Remove the cause of the malfunction to stop the

buzzer. If the cause of the problem is not removed, the

buzzer will keep sounding and the hob will switch off.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Comentarios a estos manuales

Sin comentarios

Indesit TEP 747 D L Instrucciones de uso Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Indesit TEP 747 D L